Spice Grinder 200Gr/ Hc200

Product Code: HC-200

Availability:In stock

$210.00 210.00
  • The multifunctional grinder is fine structure, low noise, small size, no vibration, compact appearance and easy operation..
  • It has high speed motor,can grind all kinds of corns, grains, herb, rice, pepper, medicine (such as ganoderma, licorice, tianqi, pearl etc) into fine powder quickly..
  • It is widely used in families, clinic, hospital, pharmacy, institute laboratories, medicine processing factory, food store and powder processing..
  • Made of food-grade stainless steel, sturdy and durable, no processing pollution, wear-resisting metal motor blade, ensure the stability and safety of the grinder for a long time to use..

Material: Stainless Steel




Rated Power: 1300W

Rotation speed:28000r/min

Working time:5 minutes; ( each time can not be use more than 5 min, between batches timing 10 min )

Interval:10 minutes

Operations Guide:

1. Open the upper cover and put the material inside;

2. Close the upper cover tightly;

3. Plug in and turn on the timer switch, then turn on the switch
for grinding (Rolling sound will be heard );

4. Turn off the switch, (When you hear the sound rolling evenly,
the material has been grinded into powder, then you can turn off
the switch);

 5. Disconnect power supply before opening;

6. Open the upper cover and brush the powder out.

Important Attentions:

⚠ Disconnect power supply before opening.

⚠ The spice grinder materials ready for grinding must be dry.
And wet, moisture or oil materials are not suitable to be grinded
into powder.

⚠ Each input material shall not exceed the rated weight or half
capacity of crush cabin so that there is enough space for powder.

⚠ After switch on, if finding the material is wet or excessive
in weight, it will jam the blade and stop the motor by giving
warning noise.So must plug out immediately to prevent motor from
being damaged. And remove the jammed object. Then restart

⚠ The spice grinder grinding work usually needs 30 seconds to 1
or 2minutes. Over time working will cause bearing overheating.


2. Chromatic aberration may occur due to the imaging principle
of the display and different shooting results.
3. Manual measurement, error 1-3cm, depending on the actual
situation, please understand.Thank you!